Welcome to JetClock
Thank you so much for purchasing a JetClock. We've tried to make clock assembly as easy as possible, and it should only take 5 minutes. No tools required!
If you run into any trouble, contact us at [email protected].
Assembly video
Let Olly guide you through the assembly, or use the instructions below.
Guided assembly video
Before you start
Check you have all the items included in the kit
| Quantity | Description |
|---|---|
| 1x | Case (Base & Cover) |
| 1x | Rasberry Pi Zero 2 |
| 1x | HyperPixel 2.1 Round |
| 1x | Micro SD Card pre-installed with JetClock OS |
If anything is missing in your kit, just get in contact with us via email at [email protected]
Assembly instructions
Assemble the clock in 5 easy steps
The SD card is the brains of your clock. Remove the micro SD card from its protective case and insert it into the side of the Pi Zero. Take the USB cable and insert it into the left hand USB slot.
Slot the micro SD card and USB cable in
Make sure the SD card is the right way round when you insert it. Don't force it in!
Place the base of the JetClock case on to the back of the Hyperpixel screen.
Align the base and screen
Keep the Hyperpixel screen flat on the table throughout assembly, the screen is delicate and it's easy to twist (and break it) accidentally.
Gently line the Pi's pins up with the Hyperpixel and then push the pins in. Use two fingers to apply a small amount of pressure to make sure that the Pi is securely resting on the black cylinders.
Push the Pi pins into the Hyperpixel
Try to be as gentle as you can inserting the Pi's pins into the Hyperpixel. If you ever need to detach the two, gently pry them apart ensuring the Hyperpixel is face down at all times.
Clip the cable into the gap in the case, and then put the case cover on.
Your JetClock is now ready! Plug it into a USB power socket. You'll now need to connect your clock to WiFi and register your clock. More information about this process is available here.
After powering on, you should see a green light flash on the back of the Pi. After a minute or two, the JetClock hotspot should appear as a WiFi network you can connect to from your phone or laptop.
Show Us Your Setup!
We'd love to see your JetClock in action! Once you've assembled and set up your clock, snap a photo and post it on Instagram - tag us @jet.clock so we can share it with the community.
FAQs
Need Help?
If you encounter any issues during setup, check out our WiFi Configuration Guide or Troubleshooting Guides.
For additional support, contact us at [email protected]
Disclaimer
This product is sold as a kit of components. The buyer is solely responsible for assembling and using the final product. OR Innovation Limited is not liable for any damage, injury, or loss arising from improper assembly or use.
© 2026 JetClock. Made in London 🇬🇧